Manticore Aerofoil Design Files

Version is now 1.2.2

Any donations will go to my new project - to give poor African kids a chance to experience flight. 
See: 
http://www.homebuiltairplanes.com/forums/hangar-flying/22492-flight-experience-african-children.html#post278357


*****************************************
* Serious file save bug in 1.2.1 fixed  *
* If you have 1.2.1 you need to upgrade *
* I had fixed a bug in the code in      *
* version 1.2.0 but not the *.fl file.  *
* This meant that when I changed the    *
* interface the bug reappeared. As it   *
* was totally unrelated to the code I   *
* changed in 1.2.1, I did not check it. *
* Sorry, folks.                         *
*****************************************


*** 1.2.2 Small change to *.dat file saving so that files will load into FreeCAD if you have the Aerofoil_Import macro. + bugfix.

*** 1.2.1 Slight changes to the interface & a couple of bugs fixed.
*** Now needs FLTK 1.3.3 for new 'Gleam' theme.***
*** Loads (most) & saves *.af files as used in NASA's 'Vehicle Sketch Pad'.***
*** Displays pressure vectors as an alternative to boundary layer ***
*** Now calculates profile as well as skin drag ***
*** CLMax is now calculated - polars should be much more accurate ***

Added a routine to automatically convert loaded vector files to coordinates (also auto converts as files are edited)
However, with this enabled, loading coordinate files is not possible - therefore the default is to disable this function.

It is now possible to set the flap root position as well as the tip in the 3D Wing window.

Several changes to the interface - most of which do not affect functionality.

A (large) number of bugs have been fixed, though there are probably plenty more ;^}

Manticore