[ v1.3.2 | v1.3.1 | v1.3.0 | v1.1.10 | v1.0.11 | v1.3.x-r10020 | Subversion ]
Developing new FTLK applications? Use 1.3.2, the first entry in the table below. The top entry will always be the lastest stable release.
Only old software should use 1.1.10, and only very old software uses 1.0.11. These older releases are end of life, and may not even compile on new platforms. Try to use 1.3; many older apps can use it with little or no change.
For more about fltk releases and development, see this article on fltk releases and the fltk roadmap.
NOTE: Dev snapshots of 2.x and 3.x have been disabled; use svn to access them.
The fltk developers voted to disable snapshots of 2.x and 3.x because
app developers were still using them for production software, despite warnings,
which is bad. Only the active release stream (1.3.x) has development snapshots now,
to avoid confusion.
The FLTK software is available via Subversion. The current active development
branch is FLTK-1.3. This can be checked out of Subversion using the
svn co http://seriss.com/public/fltk/fltk/branches/branch-1.3/ fltk-1.3
NOTE: If prompted for a username/password, just hit ENTER for both.
The previous experimental and now inactive branch is FLTK-2.0.
If you really need access, you can check this out using:
svn co http://seriss.com/public/fltk/fltk/trunk fltk-2.0
The newest development branch is FLTK-3.0. It is in pre-alpha stage, but already worth a look.
Contributions are gladly accepted. FTLK 3.0 can be checked out of Subversion using the
svn co http://seriss.com/public/fltk/fltk/branches/branch-3.0/ fltk-3.0
For further explanation about the different versions of FLTK,
see the article 'What are the Versions of FLTK?'.
Developers with write access must use https instead
of http to commit changes. For more information on
using Subversion, see the Subversion Quick-Start Guide page.